CALIBRATION
Calibration extends your warranty
MECALC’s commitment to the highest quality at every stage of a product’s life has led us to develop our own automated calibration and testing system (DCAT) to fully test and/or calibrate the scope of our products.
ISO 17025 accredited and designed to ensure products generate accurate and repeatable results over time, DCAT has been designed to test a wide variety of hardware features – significantly more than most calibration laboratories – on our highly complex products. Ensuring efficiency and consistency through the use of tailored equipment operated by Product Experts, a MECALC DCAT calibration leads to faster and more efficient results than third party vendors.
Contact us for more information on our on-site services or how to extend your warranty with a MECALC calibration.
CALIBRATION OPTIONS:
The ProCal calibration service includes a full factory test of the entire System and exercises all measurement modes on the instrument. As MECALC is ISO/IEC 17025 accredited, ProCal is offered as ISO/IEC 17025 accredited calibration or non-accredited calibration.
ProCal is a comprehensive manufacturer’s proprietary calibration. This calibration option verifies measurement accuracy plus the correct operation of internal voltage references, grounding, AC coupling, filters, noise performance, excitation voltage, integrity checking, digital channels, all connector pins, Signal Conditioning cards, Wi-Fi, SSD, batteries, handles, buttons, and many more. These tests ensure QuantusSeries Systems continue to operate as specified at every stage of their life cycle.
Calibration of Systems that may be periodically reconfigured in the field:
The QuantusSeries is a highly modular System and ProCal is designed for Systems that will be reconfigured in the field. Swapping or moving Modules between slots or Systems can then be done with confidence. And, the validity of a System calibration is preserved when a defective Module is replaced with a calibrated Module of the same type.
CUSTOM CALIBRATION SYSTEM:
DCAT is MECALC’s automated calibration and testing System used for ProCal Calibrations. Each channel is fully exercised and tested using circuits that emulate sensors, such as bridge completion resistors for calibrating a WSB42X Module.
A large System may contain tens of thousands of components that can operate in many modes and configurations. DCAT was developed to fully exercise and test these complex Systems.
For ISO/IEC 17025 accredited measurements, traceability is established by the calibrated DMM. A statement of compliance to specifications is made for every test as well as for the complete System.
